<< Vorige - Volgende >>


2 way bi-amplified bass-reflex near field monitors

Artikelcode: Std-Mon-A-Em-5


The Tweeter is used in the BLUE's is a little unusual,

it can go as low as 1000 Hz, and is supported by our molded Horn element (part of the EMES “liquid baffle design”).
This tweeter was chosen as it can assist in the reduction of Comb filter effects that can occur when the horizontal distance between the two woofers is close!
The Carbon woofers are also used in our VIOLETT HR actives and OWL-System. Using two identical woofers per box doubles the power handling, and also brings the lower System cut off frequency down to astonishing 35Hz (-3dB)!
Also very unusual in a 2 way System is the amplifier section that contains 3 amplifiers. In the BLUE R active every driver has it’s own amplifier, and again they are identical in terms of design and power rating (120W each). This gives the least distortion and the best damping control to the woofer’s coil movement!
When a powerful, precise and natural sonic image is needed, the BLUE HR active is the only choice. 
To adjust the monitors to the room acoustics and your personal listening taste, we implemented dip-switches for input level, bass- and high frequency adjustments. All of them are fixed valued Dip-Switches! So every Monitor can be set identical within minimized tolerances important for Stereo-, 5.1 and Advanced Surround™ Systems. 
We ship all our monitors as matched pairs with less than ±0,5 dB difference!

With our MODUMO™ concept: add an AMBER HR active sub unit and you can achieve a powerful 3-way main monitoring system suitable for any control room up to 40m2 (131 ft.)

We ship the BLUEs as all other EMES monitors as matched pairs!

Technical specifications:

BLUE HR active    
construction 2 way bass-reflex  
concept D'Appolito  
fc responce free field 37 - 20.000 Hz +/- 2 dB  
fc responce in wall 39 - 20.000 Hz +/- 1,5 dB  
system low fc responce 35 Hz - 3 dB  
max. sensitivity 114 dB  
max. sensitivity long term 110 dB  
harmonic distortion at SPL <100Hz 0,4 %  
harmonic distortion at SPL >100Hz 0,28 %  
Bass driver 2 x 18cm carbon  
Midrange driver -   
Hf driver 28mm Silk dome  
shielded (anti magnetic) no  
weight 18,2 Kg  
dimensions w/h/d in mm 480 x 250 x 300 mm  
pair difference +/- 0,5 dB  
BLUE HR active - Electronic   
number of amplifier 3  
power handling rms Lf/Hf 3 x 100 W  
power handling peak Lf/Hf 3 x 120 W  
connector type XLR (female)  
input impedance 10 kOhm  
input sensitivity 16 steps, from 0,45 - 4,5V  
X-over fc 1,100 Hz  
low pass filter 20 Hz / - 18dB  
Hf level control 16 steps, from -4 dB - + 4 dB  
Lf gain control 16 steps, from -6 dB - + 4 dB  
distortion at acoustic max. output 0,1%  
signal to noise ration -102 dB  
kind of power supply  analog  
operating voltage 115/230 V +/- 20%  
power consumtion at max. output 300 W  

prijs o.a.