<< Vorige - Volgende >> |
RME CARDBUSPCMCIA EU card for Digiface or Multiface Artikelcode: Std-Ra-Rm-07
|
||
The connection between CardBus card and I/O-box is established using ordinary FireWire cable (6-pin IEEE 1394a). The data transfer does not use FireWire protocol, but a proprietary bus protocol by RME. The supplied cable has a length of 4.5 m (15 ft.), a cable length up to 10 m (33 ft.) has been tested successfully. The CardBus card does not provide power to the attached I/O-box. Therefore a compact and light-weight hi-tech switch-mode power supply is included.
The CardBus shown above ships since mid 2005. In case two HDSP CardBus shall be used in one laptop, the lower card must be a flat version, which is also available. It uses a special cable (15-pin Closed LAN to 6-pin IEEE1394a, included), with a length of 4.5 meters (15 ft.). The flat card is 100% identical and compatible, but does not offer the Secure BIOS technology of the upper version.
TECHNICAL SPECIFICATIONS AND FEATURES
HDSP PCI:
Short PCI 2.0 compliant PCI card, 32 bit, 3.3 V, PCI-X compatible
Zero wait state PCI Busmaster interface (130 MB/s transfer rate in both directions)
Secure BIOS Technology: card stays fully functional even when the flash process fails
Output: IEEE 1394 connector, RME bus protocol
Package contents: PCI card, cable 4.5 meter (15 ft) IEEE 1394a
HDSP CARDBUS:
PCMCIA type II, 32 bit CardBus card
Zero wait state PCI Busmaster interface (130 MB/s transfer rate in both directions)
Secure BIOS Technology: card stays fully functional even when the flash process fails
Output: IEEE 1394 connector, RPM bus protocol
Package contents: PCMCIA type II card, cable 4.5 meter (15 ft) (IEEE 1394), switch-mode power supply 100 V-240 V/12 V - 1.25 A, car cable, battery cable
euro 299.00
|